TECHNOLOGY OF CONSTRUCTION PROCEDURES. MECHANISMS AND EQUIPMENT

The restorationof the dilapidated pipelines using compressed plastic pipes

Vestnik MGSU 2/2014
  • Orlov Vladimir Aleksandrovich - Moscow State University of Civil Engineering (National Research University) (MGSU) Doctor of Technical Sciences, Professor, Head of the Department of Water Supply and Waste Water Treatment, Moscow State University of Civil Engineering (National Research University) (MGSU), 26 Yaroslavskoe shosse, Moscow, 129337, Russian Federation; This e-mail address is being protected from spambots. You need JavaScript enabled to view it .
  • Chrenov Konstantin Evgen'evich - Moscow State University of Civil Engineering (MGSU) graduate student, Department of Water Supply, Moscow State University of Civil Engineering (MGSU), 26 Yaroslavskoe shosse, Moscow, 129337, Russian Federation; This e-mail address is being protected from spambots. You need JavaScript enabled to view it .
  • Bogomolova Irina Olegovna - Moscow State University of Civil Engineering (MGSU) Assistant, Department of Water Supply, Moscow State University of Civil Engineering (MGSU), 26 Yaroslavskoe shosse, Moscow, 129337, Russian Federation; This e-mail address is being protected from spambots. You need JavaScript enabled to view it .

Pages 105-113

The article provides the information on a promising technology for trenchless repair named Swagelining, which supposes pulling into the old pipeline the new polymer with its preliminary thermo-mechanical compression and further straightening. The coauthors present the results of the calculations determining the thickness of the polyethylene pipes after compression and straightening in the old pipeline depending on the initial diameter in case of different ratio of the diameter to the wall thickness (SDR) and the dynamics of the changes in hydraulic performance after repair work on the pipeline using the method Swagelining. The concept of the energy saving potential is formed in addition to a no-dig repair for pressure piping systems, water supply, and its magnitude. On the basis of the research results, the authors formulate the principles of the energy efficiency potential after the implementation of the trenchless technology of drawing the old pipeline with new polymer pipes with their preliminary thermo-mechanical compression and subsequent area enlargement. The technology Swagelining is described and the authors develop a mathematical model that illustrates the behavior of the pipeline in the process of shrink operations. Such parameters are analyzed as changing the diameter of the pipeline at thermo-mechanical compression, the hydraulic parameters of the new (polymer) and old (steel) pipelines, energy savings on one-meter length of the pipeline. The calculated values of the electric power economy on the whole length of the pipeline repair section with a corresponding flow of transported waters.The characteristics and capabilities of the technology of trenchless renovation Swagelining allows achieving simultaneously the effect of resource saving (eliminationof the defects and, as a consequence, of water leakage) and energy saving (reduction in the water transportation cost).A numerical example of the old steel pipeline renovation shows the calculated data, which proves the efficiency of the considered technology. The calculation results can be used as base material for designers when selecting the final decision of the alternative at reconstruction of dilapidated pipelines by Swagelining using a wide range of polymer pipes with the corresponding value of the SDR.

DOI: 10.22227/1997-0935.2014.2.105-113

References
  1. Federal'nyy zakon RF ot 17.12.2011 ¹ 416-FZ «O vodosnabzhenii i vodoot-vedenii» [Federal law of the Russian Federation from 17.12.2011 ¹ 416-FZ “On Water Supply and Sanitation”]. Konsul'tantPlyus. Available at: http://www.consultant.ru. Date of access: 24.03.2013.
  2. Khramenkov S.V. Strategiya modernizatsii vodoprovodnoy seti [The Strategy of Water Supply Networks Modernization]. Moscow, Stroyizdat Publ., 2005, 398 p.
  3. Kuliczkowski A. Rury Kanalizacyjne. Wydawnictwo Politechniki Swietokrzyskiej, Kielce, 2004, 507 p.
  4. Zwierzchowska A. Technologie bezwykopowej budowy sieci gazowych, wodociagowych i kanalizacyjnych. Politechnika swietokrzyska. Kielce, 2006, 180 p.
  5. Gal'perin E.M. Opredelenie nadezhnosti funktsionirovaniya kol'tsevoy vodoprovodnoy seti [Determining the Reliability of Water Ring Mains Operation]. Vodosnabzhenie i sanitarnaya tekhnika [Water Supply and Sanitary Engineering]. 1999, no. 6, pp. 13—16.
  6. Kuliczkowski A., Kuliczkowska E., Zwierzchowska A. Technologie beswykopowe w inzeynierii srodowiska. Wydawnictwo Seidel-Przywecki Sp. Kielce, 2010, 735 p.
  7. Metodika opredeleniya potentsiala energosberezheniya i perechnya tipovykh meropriyatiy po energosberezheniyu i povysheniyu energeticheskoy effektivnosti [Methods of Determining the Energy Saving Potential and the List of Standard Measures on Energy Saving and Energy Efficiency]. Saint-Petersburg, SRO NP «Tri E» Publ., 2011, 76 p.
  8. Rameil M. Handbook of Pipe Bursting Practice. Vulkan verlag, Essen, 2007, 351 p.
  9. Orlov V.A., Kashkina E.A. Tekhnologiya Swagelining. Opyt vosstanovleniya napornogo chugunnogo truboprovoda s ispol'zovaniem bestransheynogo metoda [Technology Swagelining. Experience of Pressure Recovery of Cast Iron Pipes with the Use of Trenchless Method]. Tekhnologii Mira [Technologies of the World]. 2011, no. 9, pp. 13—14.
  10. Govindan Sh., Val'ski T., Kuk D. Resheniya Bentley Systems: gidravlicheskie modeli. Pomogaya prinimat' luchshie resheniya [Decisions of Bentley Systems: Hydraulic Models. Helping to Make Better Decisions]. SAPR i grafika [CAD and Graphics]. 2009, no. 4, pp. 36—38.
  11. Borisov D.A. Bentley Systems — modelirovanie i ekspluatatsiya naruzhnykh setey vodosnabzheniya i kanalizatsii [Bentley Systems — Modeling and Operation of External Networks of Water Supply and Sewerage]. SAPR i grafika [CAD and Graphics]. 2009, no. 5, pp. 64—68.

Download

Results 1 - 1 of 1